Datalogic Matrix 400 - 8 Software Configuration; Visiset System Requirements; Installing Visiset

MATRIX 400™ REFERENCE MANUAL
102
8
8 SOFTWARE CONFIGURATION
Software configuration of your Matrix 400™ for static reading or simple code reading
applications can be accomplished by the Rapid Configuration procedure using the X-
PRESS™ HMI (which requires no external configuration program) or by using the VisiSet™
Setup Wizard for easy setup. These procedures are described in chapter 1.
For all other
applications use VisiSet™ through the reader serial ports (or Ethernet port for
Matrix 400™ Ethernet models only).
NOTE
Before using VisiSet™ via Ethernet, it is necessary to configure Matrix 400™
Ethernet port parameters using VisiSet™ via Main or Auxiliary serial port (for
further details refer to the VisiSet™ Help on line).
8.1 VISISET™ SYSTEM REQUIREMENTS
To install and run VisiSet™ you should have a Laptop or PC that meets or exceeds the
following:
 Pentium processor
 Win 98/2000, NT 4.0, XP or Vista
 32 MB Ram
 5 MB free HD space
 one free RS232 serial port with 115 Kbaud
 SVGA board (800x600) or better using more than 256 colors
8.2 INSTALLING VISISET™
To install VisiSet™, proceed as follows:
1. Turn on the Laptop or PC that will be used for configuration (connected to the Matrix
400™ communication ports).
2. After Windows finishes booting, insert the CD-ROM provided.
3. Launch VisiSet™ installation by clicking Install
.
4. Follow the instructions in the installation procedure.