Datalogic Matrix 410 User Manual

MATRIX 410™ QUICK GUIDE
3
STEP 1 – ASSEMBLE THE READER
The first step to perform is to assemble the accessories that make up the Matrix 410™ reader. The lens and
either an internal or an external illuminator must be used. This procedure shows an internal illuminator.
CAUTION
Matrix 410™ must be disconnected from the power supply during this procedure.
1. In a dust-free environment, remove the Matrix 410™ Lens Cover by unscrewing it.
CAUTION
Do not touch the sensor aperture, lens glass or lens cover glass. These areas must be kept
clean. Avoid any abrasive substances that might damage these surfaces during cleaning.
2. Remove the sensor protection label by pulling it off of the base.
3. Mount the lens by screwing it tightly onto the base.
If the Locking Knobs on the lens are obstructed because they are aligned behind an illuminator spacer base
and illuminator spacer, insert the Lens Spacer between the Matrix 410™ body and the C-Mount lens so that
the Locking Knobs will be unobstructed.
NOTE
It is strongly recommended to apply a lens locking sticker (provided with the lens), for
applications where Matrix 410™ is subjected to vibration.
4. If using an internal illuminator:
a. Mount the four internal illuminator spacers onto the illuminator spacer bases provided on the Matrix
410™ body.
b. Align and mount the Illuminator tightly onto the spacers using the four screws and washers provided in
the illuminator package. The spacers are positioned asymmetrically to avoid incorrect alignment.
5. To keep dust and dirt off of the lens during mounting, temporarily replace the lens cover.
Figure 1 – Assembling Matrix 410™ Accessories
Locking
Knobs
Internal
Illuminator
Lens Cover
Lens Spacer
(optional)
Illuminator
Spacers
Protective Film
(remove before calibration)
Illuminator
Spacer
Base

Datalogic Matrix 410 Specifications

General

Brand	Datalogic
Model	Matrix 410
Category	Laboratory Equipment
Language	English