CONTENTS
40
MEMOR™ 11
Image Decode Timeout
You can share any image (picture, jpg/png, etc.) with the Datalogic Service to try to
decode it. Drag the Image decode timeout slider to set the decode timeout applied
with image decoding.
Enable Multi Scan
If selected, the scanner captures multiple labels sequentially.
Number of Labels
Drag the slider to indicate the amount of labels required for a code to be confirmed.
Enable Single Notification
If selected, it enables indicators for each label, in order to get an intermediate notifica-
tion for each label decoded.
Partial Results
When multi scan mode is enabled, it selects the behaviour when partial results are pres-
ent.
Never
The decoding session is ended successfully and all the collected labels are returned
together, only if the Number of Labels is reached.
Only on Timeout
The decoding session is ended successfully and all the collected labels are returned
together, only if the decode timeout has elapsed.
Only on Release
The decoding session is ended successfully and all the collected labels are returned
together, only if the trigger is released.
Both
The decoding session is ended successfully and all the collected labels are returned
together if the trigger is released or the decode timeout has elapsed.
Presentation Mode
If enabled, the device starts to scan when motion is caught.
Aim Control
Enable aim while detecting motion.
Sensitivity
Drag the Sensitivity slider to configure the motion detector's sensitivity.
To Next Page
Loading...
