Datalogic Memor 11 User Manual

CONTENTS
USER’S MANUAL 39
Hold Multiple
When the trigger is pulled, the device scans barcodes until the trigger is released or the
decode timeout has elapsed.
Pulse Multiple
When the trigger is pulled, continuous scanning is activated until the decode timeout
has elapsed or the trigger has been released and pulled again.
Always On
No trigger pull is required to read a bar code. Scanning is continually on.
Enable Target Mode
If enabled, when the scan button is pressed, the scanner will project an aiming pattern
to assist in centering over the barcode before scanning.
Tap Target mode to select the desired targeting behavior:
Spot Timeout
Scanning takes place after a programmable time upon pressing the scan button. Tap
Target timeout to set the duration of the spot:
Release Scan
Scanning takes place after the scan button is released. Drag the Release scan timeout
slider to set the scanning timeout after releasing the scan button:
Decode Timeout
Drag the Decode timeout slider to set the maximum amount of time the scanner
attempt to decode after target timeout (in case Spot Timeout is enabled) or after the
scan button is pressed (in case Target mode is disabled):

Datalogic Memor 11 Specifications

General

Brand	Datalogic
Model	Memor 11
Category	PDA
Language	English