ARROW DOWN STRING (4-KEY MODELS ONLY) ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
229
Arrow Down String (4-key models only)
Associate a pre-defined string to the Arrow Down key
Set string for Arrow Down Key
$CDADS
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at left. Define the label string by further scanning 32
digits from the Alphanumeric characters in
Appendix D, Keypad.
The digits must be the hexadecimal ASCII represen-
tation of the desired characters; if less than the
expected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0x44776000000000000000000000000000
To Next Page
Loading...
