10 PowerScan
®
RF Scanner
Using the PowerScan RF System
This section covers the following topics:
• Battery Charging and Maintenance
• How to Scan
• LED and Beeper Indications
Battery
Charging and
Maintenance
Seat the scanner in the Base Station as shown in Figure 4, ensuring that
the battery fully engages the station’s metal contacts. The CHARGE
LED on the Base Station should flash, indicating the battery is charg-
ing.
Figure 4. Charging the Battery
NOTE
When the scanner is in use, a low battery condition
is indicated by a repeated two-flash signal from the
scanner’s green LED every time the trigger is pulled
before the laser is enabled. This indicator may have
been disabled via custom programming. See LED
and Beeper Indications for more information.
To Next Page
Loading...
Need help?
General
