Linking the Reader
Quick Reference Guide 11
Linking the Reader
Link Datalogic RF Devices to Base
For RF devices, before configuring the interface it is necessary
to link the handheld with the base.
To link the handheld and the base, either press the trigger to
wake it, or simply mount into the base to wake up for opera-
tion. If the reader was previously linked to another base, you
must first scan the
Unlink
bar code before re-linking to the
new base.
Power Off
Scan the bar code below to shut off power to the handheld
until the next trigger pull.
PowerOff
Programming
The reader is factory-configured with a set of standard
default features. After scanning the interface bar code from
the Interfaces section, select other options and customize
your reader through use of the programming bar codes avail-
able in the Product Reference Guide (PRG). Check the corre-
sponding features section for your interface, and also the
Data Editing and Symbologies chapters.
The reader can also be configured with Datalogic Aladdin™
software (available on the Datalogic website). Aladdin pro-
vides RS-232 interface configuration, as well as bar code
printing.
To Next Page
Loading...
Need help?
General
