What to do if Datalogic Automobile Accessories doesn't turn on?
If your Datalogic Automobile Accessories device isn't turning on when you press the power button, ensure it's properly connected to a power supply. Also, check that the brightness isn't set too low or too high; adjust it using the + key. Make sure you're holding the power button long enough, for at least the minimum duration set in the configuration (default 3 seconds).
How to unlock Datalogic Automobile Accessories when it's frozen?
If your Datalogic Automobile Accessories device seems frozen and you can't enter any data, try turning it off by pressing and holding the power button. Then, turn it back on.
General| Category | Automobile Accessories |
|---|---|
| Touchscreen | Yes |
| Wireless Connectivity | IEEE 802.11 a/b/g |
| Bluetooth | Bluetooth 2.1 + EDR |
| Connectivity | USB |
Instructions on how to power on and off the Rhino II mobile computer, referencing startup/shutdown modes.
Explanation of the two terminal reset methods: Warm Boot and Clean Boot (WEC7 only).
Details on the 3 modes for controlling startup and shutdown, managed via configuration files.
Explanation of the four programmable buttons on the right side of the terminal and their default functions.
Overview of DXU, a unified utility for device configuration and firmware updates via USB or network.
Detailed specifications for the Rhino II, including physical characteristics, display, buttons, mounting, and I/O.
Solutions for common operational issues, such as the device not powering on or responding.
Troubleshooting steps for issues related to network connectivity, including suspended sessions and data transfer.
Essential safety precautions for using the device, battery pack, and handling disposal.
To Next Page