Datamars ISO MAX V - Page 25

ISO MAX V Manual – v. 1.2 – july 2012 25
10.1.8 Gets the current date format
• Command syntax: “?DF” [CR]
• Command answer: [CR][LF] ”DF=#” [CR][LF]
• Command action: Gets the current date format
• Parameter range: #= 0 or 1. where 0=Europe, 1=USA
Description: this command gets the current date format.
10.1.9 Gets the current date
• Command syntax: “?DT” [CR]
• Command answer: [CR][LF] ”DT=mon 28.01.08” [CR][LF]
• Command action: Gets the current date
• Parameter range: none
Description: this command gets the current date.
10.1.10 Sets the time’s hour
• Command syntax: “.HO##” [CR]
• Command answer: [LF]
• Command action: Sets the time’s hour
• Parameter range: ##= 0 to 23.
Description: this command sets the time’s hour.
10.1.11 Sets the time’s minute
• Command syntax: “.MI##” [CR]
• Command answer: [LF]
• Command action: Sets the time’s minute
• Parameter range: ##= 0 to 59.
Description: this command sets the time’s minute.
10.1.12 Sets the time’s second
• Command syntax: “.SE##”[CR]
• Command answer: [LF]
• Command action: Sets the time’s second
• Parameter range: ##= 0 to 59.
Description: this command sets the time’s second.
10.1.13 Gets the current time
• Command syntax: “?TM” [CR]
• Command answer: [CR][LF] ”TM=14.58.45” [CR][LF]
• Command action: Gets the current time
• Parameter range: none
Description: this command gets the current time.
10.1.14 Clears the memory’s data
• Command syntax: “.rX” [CR]
• Command answer: [LF]
• Command action: Clears the memory’s data
• Parameter range: none.
Description: this command clears the memory’s data.