4
1.2.2 Charging the Battery
For optimal performance, we recommend charging the battery twice before initial use. Charge
the battery for 3 hours; disconnect the power adapter, reconnect and charge again. After this
initial charge, charge the battery for 180 minutes whenever the low battery indicator comes on
or as directed by you IT team. Follow the next procedure for charging the battery:
Plug battery charger adapter output cable in the battery charger connector as shown in
Figure 3
.
Plug battery charger adapter into the appropriate AC line voltage socket.
Battery LED will illuminate amber indicating that the battery is being charged.
The battery will be fast charged and after about 180 minutes the Battery LED will turn off
To remove the battery cartridge, open the battery door and tip the battery out of the printer.
FIGURE 3: CHARGING THE BATTERY CARTRIDGE
Note: To ensure a full charge, do not operate the printer while charging.
Note: The wall-mounted charger is a Class II equipment. Multiple plug configurations comply
with most international standards. The wall-mounted charger is not supplied with plugs for
use in Korea.
Model APEX 4
Input Voltage/Current 100-240 VAC/ 0.4A
Input Frequency 47-63 HZ
Do not use a charger not approved by Datamax-O’Neil for use with the APEX 4. Use of
an unapproved charger could damage the battery pack or the printer and will void the
warranty.
The battery terminals are well recessed inside the printer. Do not allow them to contact
conductive material since this may create a short circuit, which could cause injury or
start a fire.
When using the wall mounted charger ensure the socket outlet is close to the printer
and easily accessible during the battery recharging process. Either switch the socket
off (if supplied with a socket switch) or pull out the charger from the socket or
disconnect the plug from the printer in the event of any problems.
To Next Page
Loading...
