Datamax I-Class Mark II User Manual

Chapter 2 - Printer Setup 10
3. Route the ribbon under the Ribbon Idler and then out the front of the printer approximately 12
inches as shown.

Ribbon Roll

Ribbon Supply Hub

Ribbon Idler
4. Close the Printhead Assembly and rotate the Printhead Latch to the locked position. Route the
ribbon up and then around to the Ribbon Take-Up Hub, winding it several times in a clockwise
direction to secure it in place.

Printhead Assembly

Printhead Latch

Ribbon Take-up Hub
5. Close the cover and press the Feed button several times to position the ribbon and ensure proper
tracking.

Datamax I-Class Mark II Specifications

General

Power Supply	100-240 VAC, 50-60 Hz
Print Resolution	203 dpi
Print Width	4.09 inches
Memory	16 MB DRAM, 8 MB Flash
Connectivity	USB, Serial, Ethernet
Media Handling	Roll-fed
Media Width	1.0" – 4.65" (25.4 mm – 118 mm)
Media Thickness	0.0025" – 0.010" (0.0635 mm – 0.254 mm)
Ribbon Width	1.0" – 4.5" (25.4 mm – 114.3 mm)
Ribbon Length	1968 feet (600 meters)
Print Speed	up to 12 ips
Dimensions	12.7" H x 12.6" W x 18.6" D (322.6 mm H x 320 mm W x 472.4 mm D)