Datamax I-Class Mark II User Manual

Appendix B – Wireless and Wired LAN Setup 76
B
B
B
.
.
.
2
2
2
W
W
W
i
i
i
r
r
r
e
e
e
l
l
l
e
e
e
s
s
s
s
s
s
S
S
S
e
e
e
t
t
t
u
u
u
p
p
p
1. Open your web browser. Type in the IP Address assigned to the printer. The printers default IP
address is: 192.168.10.26.

If a different IP Address has been assigned to the printer, make sure to enter the correct IP address.
The following page will appear:
The printer’s internal web pages are divided
into 10 pages that are accessible via the
navigation bar on the left-hand side.
Most of the items on these pages mimic the
printer's internal menu. For more information
on the function of these settings see the
corresponding function in Chapter 4.

You must provide a password to change any settings, the default password is “sysadm”.

If any address parameters were changed such as IP address, subnet or gateway, the printer might
not be viewable from the current host if they are no longer on the same subnet.

Datamax I-Class Mark II Specifications

General

Power Supply	100-240 VAC, 50-60 Hz
Print Resolution	203 dpi
Print Width	4.09 inches
Memory	16 MB DRAM, 8 MB Flash
Connectivity	USB, Serial, Ethernet
Media Handling	Roll-fed
Media Width	1.0" – 4.65" (25.4 mm – 118 mm)
Media Thickness	0.0025" – 0.010" (0.0635 mm – 0.254 mm)
Ribbon Width	1.0" – 4.5" (25.4 mm – 114.3 mm)
Ribbon Length	1968 feet (600 meters)
Print Speed	up to 12 ips
Dimensions	12.7" H x 12.6" W x 18.6" D (322.6 mm H x 320 mm W x 472.4 mm D)