EasyManuals Logo

Datamax I-Class Mark II User Manual

Datamax I-Class Mark II
94 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
ii
Agency Compliance and Approvals
UL60950-1; 2
nd
Edition
CSA C22.2 No. 60950-1-07 2
nd
Edition
The manufacturer declares under sole responsibility
that this product conforms to the following
standards or other normative documents:
EMC: EN 55022 (2006) Class A
EN 50024 (1998) + A1:2001; +A2:2003
Safety: This product complies with the requirements of IEC 60950-1, 2
nd
Edition, 2005-12
ROHS: 2002/95/EC
LVD: 2006/95/EC
Warning!
This is a class A product. In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
Gost-R
GB4943-2001, GB9254-2008, GB17625.1-2003
I-4212e model:
The foregoing equipment has been registered under the Clause 3, Article 58-2 of Radio
Waves Act
FCC:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.

Table of Contents

Other manuals for Datamax I-Class Mark II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datamax I-Class Mark II and is the answer not in the manual?

Datamax I-Class Mark II Specifications

General IconGeneral
Power Supply100-240 VAC, 50-60 Hz
Print Resolution203 dpi
Print Width4.09 inches
Memory16 MB DRAM, 8 MB Flash
ConnectivityUSB, Serial, Ethernet
Media HandlingRoll-fed
Media Width1.0" – 4.65" (25.4 mm – 118 mm)
Media Thickness0.0025" – 0.010" (0.0635 mm – 0.254 mm)
Ribbon Width1.0" – 4.5" (25.4 mm – 114.3 mm)
Ribbon Length1968 feet (600 meters)
Print Speedup to 12 ips
Dimensions12.7" H x 12.6" W x 18.6" D (322.6 mm H x 320 mm W x 472.4 mm D)

Related product manuals