Chapter 4 – Menu System 45
DISPLAYED ITEM ITEM DESCRIPTION
SET FACTORY
DEFAULTS
Returns the printer settings to the factory-programmed values (except CUSTOM
ADJUSTMENTS and calibrations); or, if selected, to the Factory Setting File, where
selecting YES at the prompt causes the configuration to be restored.
FORMAT
ATTRIBUTES
Defines the manner in which overlapping text and graphics appear when printed,
where:
TRANSPARENT Intersecting text, images, and bar codes will be printed, for example:
XOR Intersecting text, images, and bar codes will not be printed, for example:
(Default Setting)
OPAQUE Intersecting text, images, and bar codes will be printed by obliterating those
formatted first, for example:
LABEL ROTATION Allows the label format to be rotated 180 degrees before printing, where:
ENABLED Flips the format.
DISABLED Does not flip the format. (Default Setting)
IMAGING MODE Determines the process used to format labels, where:
MULTIPLE LABEL Images multiple labels as memory permits to achieve the fastest throughput. If
time-stamping labels, however, the indicated time will reflect the moment of
imaging rather than the actual print time. (Default Setting)
SINGLE LABEL Images the next label only after the previous label has been printed, providing the
most accurate time-stamps but at a slower throughput rate.
PAUSE MODE Allows for controlled interactive printing, where:
ENABLED Requires you to press the PAUSE Key to print each label.
DISABLED Labels are printed without pausing. (Default Setting)
PEEL MODE Allows the printer to wait until the Start of Print signal is received (via the optional
GPIO Port) to feed a label, where:
ENABLED Inhibits the feed function until the Start of Print signal is received.
DISABLED Feeds the label regardless of the Start of Print signal. (Default Setting)
SECURITY Allows all or part of the User Interface to be password-protected and for that
password to be modified:
SELECT
SECURITY
Allows password to be set for specific User Interface areas, where:
DISABLED No password is required for menu access. (Default Setting)
SECURE MENU Sets a password requirement for User and Advanced menu entry.
MENU AND
TEST
Sets a password requirement for all menu entries.
ADVANCED
MENU
Sets a password requirement for Advanced menu entry. (After enabling this
selection, make it effective by returning the Menu Mode to the User setting; see
above.)
MODIFY
PASSWORD
Modifies the four-digit password required when security is enabled. For
modification, the code must be reentered when prompted to confirm.
To be activated, the password must initially be set to a value other than the default setting
(0000).
To Next Page
Loading...
Need help?
General
