dataTaker DT80 - Page 265

UM-0085-B09 DT80 Range User Manual Page 265
RG
Section Name
Key Name
Legal Values
Factory Default
Comment
SERSEN_PORT
(not present on
DT82E models)
BPS
300, 600, 1200,
2400, 4800, 9600,
19200, 38400,
57600
1200
Serial parameters for Serial Sensor port
See Configuring the Serial Sensor
Port (P198)
DATA_BITS
7, 8
8
STOP_BITS
1, 2
1
PARITY
NONE, EVEN, ODD
NONE
FLOW
HARDWARE,
SOFTWARE, NONE
NONE
MODE
RS232, RS422,
RS485
RS232
FUNCTION
COMMAND, PPP,
SERIAL, MODBUS,
MODBUS_MASTER,
DISABLE
SERIAL
Serial sensor port function:
command/PPP interface, PPP interface,
serial channel or Modbus
USB_PORT
(not present on
DT82E/82I models)
FUNCTION
COMMAND, PPP,
SERIAL, MODBUS,
MODBUS_MASTER,
DISABLE
COMMAND
USB port function: command/PPP
interface, PPP interface, serial channel
or Modbus
See Configuring the USB Port
(P187)
HOST_MODEM
(not present on
DT8xM models)
EXT_POWER_SWITCH
NONE
,
1RELAY
,
n
DSO
,
PWR12V
NONE
Output channel used to control modem
power
DETECTION
DSR, ALWAYS,
NEVER, WHEN_ON
DSR
Method used to detect whether modem
is present
INIT
string
AT
String to send to initialise host port
modem
MAX_CD_IDLE 0-864000
43200
(12 hours)
The number of seconds to wait while
the DCD signal is inactive before re-
initialising the modem (0=disable).
MODEM
(DT8xM models
only)
PIN
string
If SIM has a PIN set then it can be
entered here.
PIN_WAIT_S 0-86400
120
Max time to wait for user to enter PIN
via keypad
SERVICE (not DT8xM2)
AUTO, GSM 3G,
GSM_PREFERRED,
3G_PREFERRED
AUTO
Specifies the network types that the
modem to which the DT80 should
attempt to connect.
GSM_BANDS 0-7
7
Specifies the GSM bands to use
See
Network Selection (P220)
3G_BANDS (not DT8xM2)
1-511
19
Specifies the 3G bands to use
See Network Selection (P220)
REGISTRATION_WAIT_S 0-86400
60
Time allowed for modem to register on
mobile network
MIN_SIGNAL_FOR_DATA_
DBM
-113 - -51 (dBm)
-93
If signal level is below this then a data
connection will not be attempted and
DT80 will attempt to find a better
network.
SMS_ONLY
YES, NO
NO
If YES then an Internet connection will
not be established. SMS will be sent.
APN
string
(*)
Access Point Name, as specified by
mobile carrier.
APN_ACCOUNT
string
(*)
Account name if required, as specified
by mobile carrier
APN_PASSWORD
string
(*)
Account password if required, as
specified by mobile carrier
MODEM_SESSION
(DT8xM models
only)
MIN_DURATION_S 0-86400
0
Minimum communications session
duration
MAX_DURATION_S 0-86400
0
Maximum communications session
duration (hard limit, 0=disable)
MIN_IDLE_S 10-86400
120
End communications session if
communications link has been idle for
this time.
RETRY_DELAY_S
10-86400
30
Delay between session retries
TIMING_CONTROL
ALWAYS, CRON, OFF
OFF
Session will be maintained between
start and stop time, or always
START_CRON
cron-spec
0:0:12:*:*:*
If
TIMING_CONTROL=CRON
then this
specifies session start time