dataTaker DT80 - Page 266

UM-0085-B09 DT80 Range User Manual Page 266
RG
Section Name
Key Name
Legal Values
Factory Default
Comment
MODEM_SESSION
(DT8xM models
only)
STOP_CRON
cron-spec
0:0:13:*:*:*
If
TIMING_CONTROL=CRON
then this
specifies session end time
NETWORK_CHECK
DNS, PING, OFF
DNS
Method to use for checking network
connectivity.
PING_SERVERS
string
If NETWORK_CHECK=PING then this
is a comma-separated list of ping
servers
SMTP_SERVER
string
(*) Name of SMTP (email) server
SMTP_ACCOUNT
string
(*)
SMTP account name, if required
SMTP_PASSWORD
string
(*) SMTP password, if required
RETURN_ADDRESS
string
your.logger@
datataker.com
Sender email address to use in email
from logger
SENDER_NAME
string
Sender name to use in email from
logger (if blank then logger model/serial
used)
DDNS_ENABLE
YES
,
NO
NO
Enable Dynamic DNS client
DDNS_SERVER_URI
string
members.dyndns.
org/nic/update
DDNS server "address update" URI
DDNS_SERVER_PORT
0-65535
80
DDNS server port number
DDNS_ACCOUNT
string
DDNS account name
DDNS_PASSWORD
string
DDNS password
DDNS_HOST_NAME
string
Configured logger domain name
associated with DDNS account
ETHERNET_
SESSION
SMTP_SERVER
string
Name of SMTP (email) server
SMTP_ACCOUNT
string
SMTP account name, if required
SMTP_PASSWORD
string
SMTP password, if required
RETURN_ADDRESS
string
your.logger@
datataker.com
Sender email address to use in email
from logger
SENDER_NAME
string
Sender name to use in email from
logger (if blank then logger model/serial
used)
RETRY_DELAY_S
10-86400
30
Delay between session retries
ETHERNET
ENABLE
YES, NO
YES
Enable Ethernet port
IP_ADDRESS
n.n.n.n or AUTO
AUTO
IP address to assign to the DT80's
Ethernet port
AUTO = use DHCP to automatically set
IP address, subnet mask, gateway and
DNS servers.
SUBNET_MASK
n.n.n.n
255.255.255.0
Subnet mask for the network segment
connected to the DT80's Ethernet port.
Ignored if IP_ADDRESS=AUTO.
GATEWAY
n.n.n.n
0.0.0.0
IP address of the computer that acts as
a gateway to other networks.
Ignored if IP_ADDRESS=AUTO.
PPP
USER
string
DATATAKER
User name and password that a remote
PPP client must supply in order to
connect to the DT80 via PPP (not
required for USB port)
PASSWORD
string
DATATAKER
FTP_SERVER
PORT 0-65535
21
TCP port number used by FTP server
(0=disable)
USER
string
DATATAKER
Username and password that an FTP
client must supply in order to be
granted read/write access.
PASSWORD
string
DATATAKER
ALLOW_ANONYMOUS
YES, NO
YES
If YES, read-only FTP access is
permitted for anonymous users
If NO, all FTP users must login using
the configured username and
password.
NETWORK
DNS_SERVER_1
n.n.n.n
0.0.0.0
IP address of primary DNS server.
Ignored if IP_ADDRESS=AUTO.
DNS_SERVER_2
n.n.n.n
0.0.0.0
IP address of secondary DNS server, to
be used if primary server is unavailable.
Ignored if IP_ADDRESS=AUTO.
COMMAND_SERVER PORT
0-65535
7700
TCP port number used by command
interface (0=disable)