Datavideo PTC-200W - Page 29

29
5:
SYSTEM
6:
CAMERA SET (ADVANCE)
7:
RESET P/T/Z
8:
ESCAPE
7. Select “SET DVIP.”
[REMOTE CONTROL]
1:
PAN/TILT REVERSE: P+T
2:
REMOTE SOURCE: DVIP, SW
3:
SET RS422
4:
SET DVIP
5:
SET IR
6:
PTZ INFO. OUTPUT: OFF
7:
ESCAPE
8. Set DVIP baud rate to 115200.
[SET DVIP]
1:
DVIP BAUDRATE: 115200
2:
ESCAPE
9. Connect your PC directly to the DVIP port on the PTC series camera or if in
a multiple DVIP device environment, connect all devices to an Ethernet
router. Please note that the router and the connected devices should be
in the same IP range.
10. On the PC, open the DVIP Configuration Tool by double
clicking “DVIP_Net_Conf.exe.” The DVIP Configuration Tool
can be obtained from Datavideo local distributors or
downloaded from the product page.
11. After the DVIP Configuration Tool is opened, select your network
interface card and click the “OK” button.
Note: Make sure you select the card that is on the same network as the
camera or else the DVIP Configuration Tool will not be able to find the
connected DVIP devices.