Davicom Cortex 360 - Setting Internal Jumpers and DIP Switches; Configuration; System Menu Configuration; Configuring the Cortex 360 IP Parameters (General Tab)

14
Setting Internal Jumpers and DIP Switches
For more information on how to set the internal jumpers and DIP switches, please
refer to this article.
Configuration
Important
Please note that the Cortex menus and screens are dynamic user-dependent,
meaning they will show more or less information based on a user’s access level, and
whether a user is in control of the unit or not. If you notice that certain buttons or
control/command settings seem to be missing or are greyed out, first check if you
are (still) in control, or make sure you have proper access level / access rights.
System Menu Configuration
Configuring the Cortex 360 IP Parameters (General tab)
The IP configuration menus set all the IP-related parameters required for the Cortex
to communicate via network connection.
1. Go to the System menu.