13
CT Series Traction Control
www.moretraction.com
Correction Hold (0-15, default=7) is used to force the
TC system to hold the correction for X many
revolutions of the crankshaft to give the vehicle some
time to recover before the correction is removed.
SmartDrop® is a method of dropping cylinders to
cause large reductions in torque. The cylinders will
drop cylinders in a smooth pattern and not drop the
same cylinder until all other cylinders have been
dropped. Valid SmartDrop® values are 0-4. If set to
the maximum value of 4, then 4 out of 8 cylinders
will be dropped on a V8. A setting of 1 will drop 1
out of 8, 2 will drop 2 out of 8 and 3 will drop 3 out of
8. Dropping cylinders is only used in severe tire
spin situations, and will be heard.
To Next Page