Ramp In (10-1000, default=150) is the rate at which
timing retard is restored after a correction has
ended. Ramp in is calibrated in degrees per second.
150 will restore 150 degrees in one second, or 15
degrees in 1/10
th
of a second. So, if timing is
retarded 15 during a correction, a setting of 150 will
return timing to normal over 1/10
th
of a second.
Self Learning (on-off, default ON) if installed, can be
disabled, and the TC can be used in Non-Self
Learning Mode. This may be useful on rough or
bumpy tracks.
Display Timeout (on-off, default ON) disables the
screen timeout. This is useful during initial setup
so, it will not automatically return to the Main Menu
if no buttons pressed for a few seconds. Display
timeout will return to ON after a power cycle.
Note: If the unit is left in an adjustment screen, it will
not read RPM and will never go active on the track.
Points (None, PassThru, Alt Map, default None) sets
To Next Page