15
CT Series Traction Control
www.moretraction.com
the output mode of the points output trigger wire.
This must be set correctly for your type of ignition for
the unit to operate properly. If not set properly, the
engine may not run or could misfire.
Mode configures the unit for the specific ignition
system you are using. You must select the proper
mode for your ignition for the unit to operate properly.
Failure to do so could result in improper ignition
timing retard calibration, erratic behavior or a misfire
in the engine. Mode is only visible as a menu item on
some hardware models. See the table below.
6AL, 6ALN, 6T, 6TN, HVC™ Crane®, FAST™
(Set Points Output to “None”)
(Set Points Output to “None”)
Mode is only visible as a menu item on some models.
Note: Davis Technologies is constantly adding
compatibility with different types of ignitions, call if
your ignition is not listed.
All trademarks used herein are the property of their respective owners.
MSD®, HVC™ and Pro Mag® are registered trademarks of
Autotronic Controls Corporation.
FAST™ is a registered trademark of Fuel Air Spark Technology.
Crane® is a registered trademark of Crane Cams®
To Next Page
Loading...
Need help?
General