16
CT Series Traction Control
www.moretraction.com
Manual In (On/Off, default=Off) On units where pin 6
(Green) is not used for trigger input, the input can be
used to manually control a timing retard with a push
button. Applying battery positive voltage to pin 6
(GPI1) will trigger a retard, set by the Manual Retard
setting. When the button is released, the timing will
ramp back in at the Ramp In rate.
Manual Retard (0-20, default 0) Sets the amount of
retard that will be removed from the ignition timing
when the Manual In button is pressed.
Max SD (0-4, default 0) Max SD is the maximum
amount of cylinders that will be dropped when
SmartDrop® is active. SmartDrop® will drop
cylinders in a smooth pattern and not drop the same
cylinder until all other cylinders have been dropped.
Dropping cylinders is only used in severe tire spin
situations,
To Next Page
Loading...