17
CT Series Traction Control
www.moretraction.com
RPM Settings
The CT Series can be configured to operate in
different modes based on engine RPM. The different
modes are indicated on the multi colored LED.
Once turned on, the unit is in “waiting” mode until
the Auto Start RPM is exceeded the first time.
Waiting mode is indicated on the LED with a short
Blue blink.
Once the Auto Start RPM is exceeded, the unit is in
“Active” mode, indicated on the LED with a solid
Green glow. If a timing retard correction is active,
the LED flashes Red.
If the RPM is above the Max RPM or below the
Minimum RPM, the LED will glow solid Blue.
If the RPM drops below the Minimum RPM for a
duration longer than the End Time setting, the unit
returns to Waiting mode until the Auto Start RPM is
exceeded. This is very useful to automatically turn
the corrections off during a yellow flag, and not
make corrections until the Auto Start is exceeded
again. If you prefer to restart the race with the
system active after a caution, make certain to
exceed the Auto Start RPM before the green flag.
To Next Page
Loading...
Need help?
General