DCS Delius User Manual (English)

Questions and Answers:

K
Karen DickersonSep 6, 2025
What to do if the Left and Right channels are swapped on my DCS Delius?
- M
  michaeledwardsSep 6, 2025
  Check that the audio output cables are not reversed. Open the menu and check the Swap page; if it is set to Swap-On, change it to Swap-Off. Ensure that the channels are not swapped elsewhere in the system. If you are using Dual AES mode, ensure that AES 1 input is connected to the output on the source equipment carrying the Left channel data and the AES 2 input is connected to the output on the source equipment carrying the Right channel data.
C
Cameron RiggsSep 7, 2025
Why does my DCS Delius Media Converter unit fail to respond to the controls?
- R
  Robert Romero DVMSep 8, 2025
  Check that the STBY indicator is not lit. If it is, press the Power/Standby button to return to normal operation. Alternatively, switch the unit off, wait 10 seconds, and switch it back on to cancel Standby mode. While the unit is locking to a source or changing settings, it will not respond to new commands for a few seconds. If the Mute fade-out rate is set to Mute-Slw, the unit may be unresponsive while slow muting is in progress. Short mains supply drop-outs may cause the microcontroller to lock up; switch the unit off, wait 10 seconds, then switch it back on.
A
Anthony TannerSep 9, 2025
What causes power interruptions in DCS Media Converter?
- K
  kristen12Sep 9, 2025
  Power interruptions can be caused by loose AC power wiring, local power-line overloads, or heavy-duty appliances like air conditioners. If this occurs frequently, please consult your dealer.
D
Dr. Laurie RobinsonSep 12, 2025
What to do if my DCS Delius Media Converter will not decode Dual AES?
- C
  carlawolfeSep 12, 2025
  Dual AES mode may be disabled. Open the menu and set the Dual AES page to On. Connect a valid 88.2, 96, 176.4, or 192kS/s Dual AES source to both AES 1 and AES 2 inputs. Press the Input selector button repeatedly until both AES1 and AES2 indicators are lit. Your source equipment may have two AES outputs but might not be capable of Dual AES operation. Check the manual for the source equipment.
T
Terri Maldonado MDSep 12, 2025
What does it mean if the main display turns on briefly when a control is operated, then turns off on my DCS Delius?
- J
  James NashSep 12, 2025
  This occurs when the Display Brightness is set to Bright 0. Change to any other brightness setting to stop the display blanking out.