DCS Delius - IEEE 1394 Interface; Mains Supply Voltage; Having Your Options Changed; Table 9 - Options Available

dCS Delius User Manual Manual for Software Issue 2.3x
dCS Ltd September 2004
Manual filename: Delius Manual v2.3x.doc Page 58 email: more@dcsltd.co.uk
English version web-site: www.dcsltd.co.uk
OPTIONS
The following options may be fitted to new units or retrofitted at a later date.
Option code Option
1394 IEEE 1394 interface
V5 Mains voltage set to 230/240V
V4 Mains voltage set to 215/220V
V3 Mains voltage set to 200V
V2 Mains voltage set to 115/120V
V1 Mains voltage set to 100V
Table 9 – Options available
IEEE 1394 Interface
We can fit an IEEE 1394 interface to enable the unit to generate / receive DSD
data on either of two 6-way connectors. The cost of this option depends on the
age of your unit. Note the full serial number of your unit and contact your dCS
distributor for advice. This option must be fitted at dCS to allow full checking.
See the “Rear Panel” section on page 39 and “IEEE 1394 Overview” on page
50.
Mains Supply Voltage
Any unit may be set for operation from 230/240V, 215/220V, 200V, 115/120V or
100V A.C. Units are shipped set for the mains supply voltage according to the
destination. The voltage setting can be updated later by your dealer, if
necessary. Specify the new country of use or the new voltage setting.
Having Your Options Changed
dCS support modifications, updates and option changes to supplied units. Major
changes are normally carried out at dCS as we have extensive test facilities and
can verify the changes. Please contact your dealer / distributor or dCS for
details.
IMPORTANT! Please do not attempt the changes yourself. The unit’s performance or
reliability may be impaired and the warranty will be invalidated.