OVEN SELFCLEANING MODE
• Turn on the ventilator hood above the range and leave it on until after the oven has completed the
self-clean cycle.
SETTING THE OVEN FOR SELF CLEAN
1) Push the"CLEAN" Selector Button.
2) Set Oven Control Knob to "CLEAN".
• Cooling Blower turns on,
• OVEN ON light and HEATINGlight turn on,
• LOCK light turns on,
• The door closing process takes approximately 60 seconds to complete, at which
time the door becomes locked.
ATTHE END OF THE CLEAN CYCLE:
ThecleancycletakesShoursto complete.TheOVENON
light turnsoffoncethe cyclehasfinished.
1) Push the OFF selector button. The door latch will open
automatically after the oven temperature falls below
550°F and the automatic door lock completes its
60 sec. cycle to the OPEN position.
2) Turn the oven control knob to OFF. Wipe white ash
with a damp cloth or sponge (after oven has cooled)
before placing oven racks.
Fig. 13
3) Replace the oven rack slide assemblies by:
A) Guiding the rear of the rack slide assembly into the bottom rear bracket of the
oven side,
B) Guide the top rear of the rack slide assembly into the top U-shaped bracket of
the oven side,
C) Lift up the Push Rod so that it restson the"ledge"of the side support of the
assembly, and
D) Screw the assembly secure to the oven through the hole in the front middle
section of the side support. Repeat for the other side of the oven.
4) Replace the oven rack
//_ WARNING:
Theinteriorofthe ovenwill stillbe at bokingtemperatures whenthelocklight
turns offand the ovendoor conbeopened.Usecautionostheovenmay be hot
enough tocouseburns.
25
To Next Page
Loading...
