CARE AND MAINTENANCE
OVEN RACKS AND RACK SUPPORTS
All of the oven racksand 12"rack supports are chrome plated steel. The roller assisted rack supports
in the main oven are stainless steel. To remove the 12"Oven rack supports, first remove the oven racks,
then grasp the rack supports and pull up and out. To replace the rack supports, put the top in first. See
page 2.5 for removal of the self cleaning Oven Roller Assisted Rack Support Assemblies. Do Not
immerse the self cleaning Rack Slide Assemblies or wash in a dishwasher. Usea damp sponge, cloth, or
steel wool with a mild detergent to clean. Chrome cleaners, such as Soft Scrub,Cameo or Bar Keepers
Friend can be applied with a damp sponge following package directions. Rinse and dry. Powdered
cleaners such as Bon-Ami or Comet are applied with a dam p sponge or cloth, rubbed lightly, rinsed and
dried. Forhard to remove food soiluse a dampened soap filled steel wool pad, rinsed and dried. Harsh
Cleaners which are commercial oven cleaners,such as EasyOff or Dow can be used on the racks,but
are not recommended for use on the self cleaning oven rack slide assemblies or oven interiors.
Additionally, some commercial oven cleaners cause darkening and discoloration. Test the cleaner on a
small part of the rack and check for any discoloration before cleaning the entire rack. Apply a
generous coating. Allow to stand for 15 to 20 minutes. Rinsethoroughly and dry. After being cleaned,
if the racks do not slide easily, pour a small amount of cooking oil on a paper towel and rub it lightly
over the side rails.
FRAME, SIDES, DOOR EXTERIOR, HEAT DEFLECTOR
These parts are made of stainless steel, follow the directions for the Backguard. Take care when
cleaning the door top, and do not let water or cleaners run down the vents. If water or cleaners spill
into the vents, they may streak the glass inside the door.
DOOR GASKET
Usea generalkitchenspraycleaner,suchasFormula409®or Fantastik®.Sprayiton andblotdrywith a
cloth. Do notrub. Do not removeor damagethe mesh.
OVEN LIGHT BULB REPLACEMENT
Forovenlight bulb replacementuseonlya 40 watt, 120 volt appliancelight bulb,Theseare available
insupermarkets.DONOTusea standardlightbulb inany oven,the heat will breakit.
To Replace the Light Bulb
1) Be sure the oven light bulb switch isin the off position or turn off circuit breaker. The bottom of the
switch is pressed in. Let the cover and the bulb cool completely.
2) Remove the light cover. Turn the cover to the left (counterclockwise) to unscrew it.
3) Remove the burnt out bulb. Replace it with a 40 watt appliance light bulb only.
4) Replace cover. Turn circuit breaker back on, if turned off. (See Caution).
z_ WARNING:
Besuretheovenlight switchisin the OFFpositionand the coveris cool.If the
bulb comesloosefrom the base,turn off the power to the ovenat thecircuit
breokerponel,beforeattemptingtoremovethe bulbbasefrom thesocket.
POWER FAILURE
The broiler and oven burners cannot be turned on during a power failure. To light the open top
burners, turn the control knob to "LITE"hold a lighted match to the port ring. After the flame is burning
allthe way around the burner, adjust the fiame. It isnecessaryto light each burner separately,each time
you want to use it.
3O
To Next Page
Loading...
