SAFETY PRACTICESAND PRECAUTIONS
• Place oven racks in desired position while the oven iscool.If a rack must be moved while the oven
is hot, do not let the pot holders contact the hot interior of the oven.
• Use care when opening the oven door; let hot air or steam escape before removing or replacing
foods.
• Donor rub, damage, moveor removethedoorgasket. Itisessentialforagoodsealduringbaking.
• Clean the ventilator hood and filters above the range or cooktop frequently so grease from
cooking vapors does not accumulate on them.
• Turn the ventilator OFF in caseof fire or when intentionally"flaming" liquor or other spirits on the
cooktop. The blower, if in operation, could unsafely spread the flames.
• DO NOT obstruct the flow of combustion or ventilation air to the appliance. Be sure a fresh air
supply is available.
• For safety reasonsand to avoid damage to the appliance never sit, stand, or lean on the oven door
or cooking surface.
• Service should only be done by authorized technicians.Technicians must disconnect the power
supply before servicing this appliance.
//_ WARNING:
California Proposition 65 - The burning of gas cooking fuel generates some
by-products which are known by the State of California to cause cancer or
reproductive harm. California low requires businesses to worn customers of
potential exposure to such substances. To minimize exposure to these
substances, always operate this unit according to the instructions contained in
this booklet and provide good ventilation to the room when cooking with gas.
RECOMMENDATIONS ON HOOK-UP TO GAS SUPPLY:
A manual valve must be installed external to the appliance, in an accessible location from the front
for the purpose of shutting off the gas supply. The supply line must not protrude beyond the back
of the unit. Make sure the gas supply is turned off at the wall valve before connecting the
appliance.
The gas supply connections should be made by a qualified technician and in accordance with local
codes or ordinances. In the absence of a local code, the installation must conform to the National Fuel
GasCode ANSI 223.1-1988, latest edition.
NOTE: Thisproduct must be installed byo licensedplumber or gas fitter when
installed within the Commonwealth of Massachusetts.
NOTE: Alternate method of supplying
gas (mandatory for the State
of Massachusetts)installation
into the unit.
o o OOOo,111_/.,,__.
5
To Next Page
Loading...
