8
4.2 (Optional) Installing the Rear Camera
Note: This section is Only applicable to users who have purchased the rear camera. If you have not purchased one,
please skip this section.
1. Clean the rear windshield (the approximate installation position of the rear camera Is shown in the figure below).
2. Take out the rear camera and the power cable and connect them.
3. Insert the rear power cable fully into the N3 Pro headphone jack.
Caution: Please make sure that the power cable is fully plugged into the jack, if not, the rear camera indicator will
not on, and the rear camera will not work.
4. Route the rear power cable from the N3 Pro to the rear camera, cable routing is shown in the figure above.
5. Remove the red backing film of the adhesive, and adjust the field of view of the rear camera, then fix the rear
camera to the inner wall of the rear windshield.
To Next Page
Loading...
