7
4.1.3 Installing the N3 Pro onto Your Windshield
● After performing the power-on checking, please confirm the N3 Pro is connected to the DDPAI app normally.
● Do not install this product or perform any other operation to set up this product while driving.
1. Select an appropriate place to locate the N3 Pro and clean this area:
You are recommended in most cases to install the N3 Pro on your front windshield (Next to the rearview mirror on
the driver’s side), as shown in the figure below.
Clean the location area on the windshield with a clean and soft cloth from dust, plastic, and other stuff, to ensure
that the N3 Pro can be firmly attached to the front windshield.
Use the vehicle wire trim tool to run the power cable along the front windshield and the roof, and hide the cable on
the A-pillar, so as to not block the driver’s sight and cause danger.
2. Locate the installation position based on the guidelines:
After connecting the N3 Pro to your phone, you will see the horizontal and vertical installation guidelines on the
screen to assist with installation, according which the installation position of the N3 Pro is located:
● Vertically: Moving the N3 Pro side to side with the help of the vertical guideline on the middle of the
screen, keep adjusting until to the middle of the vehicle’s front end align to this vertical guideline.
● Horizontally: Rotating the camera up and down with the help of the horizontal guideline on the middle of
the screen, keep adjusting until the ground-level horizon outside vanishes from the scope of this horizontal
guideline.
3. Fix the N3 Pro in place.
After locating the installation position, attach the electrostatic sticker and remove the red backing film from the 3M
adhesive sticker on the back of the N3 Pro. Then attach the N3 Pro to the predetermined location, ensuring that
the 3M adhesive sticker on the back is firmly attached to the windshield. The camera is facing towards the front of
the vehicle.
The optimal installation position
To Next Page
Loading...
