To Next PageTo Next Page
Need help?Do you have a question about the Dea NET230N and is the answer not in the manual?
General| Power Supply | 24 V DC |
|---|---|
| Input Voltage | 24 V DC |
| Output Voltage | 24 V DC |
| Maximum Current | 2 A |
| Protection Class | IP20 |
| Communication Interface | RS485 |
| Operating Temperature | -20°C to +60°C |
Procedure for initial configuration of inputs, outputs, and parameters upon first use.
How to change the control board's configuration after it has been previously set up.
Describes the initial display sequence upon powering up the control panel.
How to view the status of inputs and operation counters on the display.
Selects the type of gate operator to ensure proper system compatibility and functionality.
Configures the control panel for operators that use an encoder or not.
Sets the control panel to operate with one or two motors.
Sets the direction of motor movement for opening and closing.
Procedure for adjusting the physical limit switches that define gate travel.
Teaches the control panel the full opening and closing travel of the motor.
Process for programming remote control transmitters to operate the system.
Modifies various operational settings like force, speed, and timing.
Indicates the end of the programming procedure and readiness for use.
Procedures for removing programmed transmitters from the system's memory.
Resets specific or all operating parameters back to their factory default values.
How to enable or disable access to programming functions for security.
Saving and loading system configurations to/from an external memory unit.
Assigning specific functions to the control panel's input terminals.
