Decagon Devices KD2 Pro - Setting Device Date and Time; Configuring Auto Mode

KD2 Pro 4 THE KD2 PRO UTILITY
Note: If you encounter an error message, please refer to the
Troubleshooting section for instructions.
4. A progress bar shows the status of the erase process.
4.6 Setting the Date and Time
You can set the KD2 Pro date and time by selecting “Set KD2 Pro
Date/Time...” from the Actions Menu. This automatically syncs the
KD2 Pro date and time to your computer time.
4.7 Setting the Auto Mode
The Auto mode of the KD2 Pro allows you to perform automatic
and autonomous measurements at specified time intervals. The KD2
Pro has pre-set measurement intervals to select for this mode, but
you can better customize how the KD2 Pro operates in Auto mode
using the KD2 Pro Utility software. For example, you can select
specific measurement intervals, delayed start times, and the number
of measurements from this menu.
Follow steps 1 through 3 to configure Auto Mode with the KD2
Pro Utility.
1. If the correct port is not automatically chosen, select the appro-
priate serial communication (COM) port from the “Use com-
puter communication port” control on the Main screen.
2. Choose “Configure Auto Mode...” from the Actions Menu. The
Configure Auto Mode screen appears.
37