Need help?Do you have a question about the Decagon Devices AquaLab 4TE and is the answer not in the manual?
General| Brand | Decagon Devices |
|---|---|
| Model | AquaLab 4TE |
| Category | Measuring Instruments |
| Language | English |
Details the steps for setting up and turning on the AquaLab, including warm-up.
Describes how to start the verification and calibration process.
Displays component values for performance checks.
Provides instructions for accessing the sample chamber and cleaning its components.
Outlines the multi-step washing, rinsing, and drying procedure for cleaning.
Explains the importance of checking instrument performance after cleaning.
Explains how to verify AquaLab's water activity calibration using standards.
Describes specially prepared salt solutions used for verification.
Details when to verify for linear offset.
Provides steps for verifying linear offset using a calibration standard.
Guides the user through the process of adjusting the instrument's linear offset.
Provides essential steps for preparing samples for accurate AquaLab measurements.
Step-by-step guide on how to perform a measurement with the AquaLab.
Explains how the DUO measures moisture content using loaded product models.
Describes how to take readings with the DUO, similar to standard operation.
Explains how to adjust moisture content calculations to match reference methods.
Provides detailed steps for adjusting linear offset or creating new models.
Solutions for the AquaLab failing to power on.
Troubleshooting steps for slow or inconsistent measurement readings.
Solutions for incorrect verification standard readings and linear offset issues.
Explains the 'Sample too hot' warning and how to resolve it.
Addresses the error message indicating the sample is too dry for measurement.
Solutions for a dew point sensor failure error message.
Steps to take when verification results are incorrect.
Explains the 'Crystal Failure' error and its potential solutions.
Solutions for the 'Contaminated mirror' error message.
Addresses the error indicating corrupted firmware.
Solution for running a DUO test with an incorrect product model.
Troubleshooting steps when DUO moisture content display is inaccurate.
Solutions for when moisture content is not displayed on the DUO screen.
To Next Page
