8
The PosiTector App features probe hot-swap. During the
measurement process, probes can be interchanged without the need
to go back to the Search screen. Simply swap probes (PosiTector
SmartLink will power-down) and then power-up the PosiTector
SmartLink. The PosiTector App will automatically recognize the probe
and be ready to measure.
NOTE:
Power-up / Power-down
The PosiTector SmartLink powers-up when the LED button is pressed.
To preserve battery life, the PosiTector SmartLink powers-down after
5 minutes of no activity. Alternatively, press and hold the LED button
until it turns red and shuts off (approximately 5 seconds). All probe
settings and calibration adjustments are retained, stored measurement
data is retained within the smart device.
Tri-Color LED Button
The LED visually provides connection and measurement status.
LED Color Status:
Blue Blink = Not Connected to PosiTector App
Blue Solid = Connected to PosiTector App
Green Blink = Successful Measurement
To Next Page
Loading...
