12
Factory Cal settings can be restored at any time by creating a
New Cal setting (pg 27), by Resetting the Current Cal (pg 28) or by
performing a Reset (pg 30). The X symbol appears on the
display whenever factory Cal settings are in use.
With “FN” probes, calibration adjustments (pg 23) are made only to
either the “F” or “N” mode (stored independently under a particular
Cal), whichever was measured last.
Menu Operation
Menu Operation
PosiTector 6000 functions are menu controlled. Access them by
selecting Menu in the upper right of the PosiTector App display.
The Main Menu contains the following sub-menus...
Memory (pg 13)•
Statistics (pg 21) •
Cal Settings (pg 23)•
Setup (pg 29)•
Select Exit to close the menu.
To Next Page
Loading...
