30
Menu Reset (PosiTector App)
Select Reset from Setup Menu.
The following occurs after a warning
message:
All stored batches, measurements,•
images, notes, annotations are
deleted.
All calibration settings (adjustments)•
and Cal Memory are cleared and
restored back to factory settings
(provided PosiTector SmartLink is
ON and connected to App).
To keep calibration settings, power
off the PosiTector SmartLink prior to
performing this Menu Reset.
Settings are returned to
the following:
Memory = OFF
Statistics = OFF
Units = Metric
HiLo Limits = OFF
N Lock = OFF
Cal Lock = OFF
Report Configuration
Settings = restored to
default
Reset
Restores factory default settings. Ideal for returning settings to a
known condition. There are two available Reset options:
Menu Reset and PosiTector SmartLink (LED button) Reset (pg 31).
Scan
In ordinary operation, the PosiTector 6000 probe takes thickness
readings every 2 seconds when placed onto a surface. Normally, the
user raises the probe after it has taken a single reading and relocates
it to a second location. Scan mode modifies this behavior in two ways.
First, measurements are taken much faster.
Second, all readings are recorded when memory is ON. As the probe
slides along the surface in scan mode, single readings are taken in
quick succession. This may reduce the life of the probe.
Recommended for smooth surfaces only.
Fast
Increases measurement speed for most probes. Useful for quick
inspection or when measuring large areas with thick coatings where
proper probe positioning is not critical. Swift up/down probe movement
is required. Reduced accuracy may be noted.
To Next Page
Loading...
