Page 13
Installation and connection
This appliance can only be installed and
connected in accordance with the statutory
installation rules.
DANGER Risk of electric shock,
short circuit or fire by
unprofessional installation!
The appliance may be connected to
the mains supply only by an
authorized qualified person and the
appliance is only guaranteed after
correct installation.
DANGER Risk of electric shock,
short circuit or fire by damage of
the mains lead!
The mains lead must not be
clamped, bent or trapped or come
into contact with hot parts of the
appliance. If the mains lead is
damaged, it must be replaced by a
qualified electrician.
x Connection must comply with national
regulations.
x The mains supply data must correspond to
the data specified on the type label of the
appliance. The rating plate is either seen
when the door or the lower cover is
opened or it is located at the rear wall of
the unit depending on the unit type.
x The power cable of your appliance must
comply with the values in "Technical
specifications" table.
DANGER Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from the
mains supply.
The power cable plug must be within
easy reach after installation (do not
route it above the stove)
Gas connection
DANGER Risk of explosion or
poisoning by unprofessional
installation.
The appliance may be connected
to the gas distribution system only
by a registered LPG installer.
DANGER Risk of explosion!
Before starting any work on the
gas installation, please shut off
the gas supply.
x Gas adjustment conditions and values are
stated on labels (or on type label).
Your appliance is adjusted for
LPG gas.
Electrical connection
Connect the appliance to a grounded outlet/
line protected by a fuse of suitable capacity
as stated in the "Technical specifications"
table. Have the grounding installation made
by a qualified electrician while using the
product with or without a transformer.
The manufacturer shall not be held
responsible for damages arising from
procedures carried out by unauthorized
persons.
x Plug the power cable into the socket.
Do not install the appliance next to
refrigerators or freezers. The heat
emitted by the appliance will lead
to an increased energy
consumption of cooling
appliances.
Carry the appliance with at least two
persons. The appliance must be placed
directly on the floor. It must not be placed
onto a base or a pedestal.
Material damage!
The door and/or handle must not
be used for lifting or moving the
appliance.
To Next Page
Loading...
