EasyManua.ls Logo

Defy DGS161 - Connecting the Gas Hose; Gas Leakage Control; Adjusting Oven Feet for Leveling

Defy DGS161
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 14
Connecting the gas hose
x Have your appliance connected so that it
will be close to the gas connection.
Ensure that there is no gas leakage.
x Gas bottles should be located outdoors in
a suitable ventilated lock-up.
x The connecting hose to be used must not
be longer than 125 cm in length.
x Fit the clamp to the hose. Soak one end
of the hose (15 mm inner diameter) into
hot water for 60 seconds to soften, then
slip the softened end of the hose
completely onto the sharp hose tip of the
appliance.
x Secure the hose by tightening the hose
clamp.
x Repeat the same procedure for the other
end of the hose by securing it to the
regulator on the gas bottle to complete the
gas cylinder connection.
x Always check for gas leaks after
installation and whenever a new or refilled
gas bottle is used for the first time.
DANGER Risk of explosion and
suffocation! LPG bottles must not
be stored in the house.
Leakage control at the connection point
x Ensure that the control knobs on the hob
are in the OFF position.
x Open the valve on the Gas bottle.
x Using a small paint brush, apply some
soapy water to all the connections.
x If there is a leak, bubbles will appear.
x If this occurs, close the gas bottle valve .
x Check and tighten the connections
immediately.
x Repeat the procedure to ensure that there
are no further leaks.
Adjusting the feet of oven
Level the appliance to ensure stability of
cooking vessels whilst cooking.
For your own safety please ensure the
product is level by adjusting the four feet at
the bottom by turning left or right and align
level with the work top.
4 feet are supplied together with your oven.
Each foot must be installed into its
respective slot located at the 4 corners
under the oven.
Screw the thread of the foot by turning in
clockwise.
For your safety, make sure that all 4 feet are
level when screwing in. An oven that is not
level will have an adverse effect on cooking.
1. Hose tip-LPG
2. Hose tip-NG
3. Safety hose
4. O-ring (gasket)
5. Clamp
x Push the product towards the kitchen wall.
1 Foot
2 Foot slot
Caution: Never use a naked flame to
check for gas leaks
DANGER Risk of explosion by
damage of the safety tube!
The safety tube must not be clamped,
bent or trapped or come into contact
with hot parts of the appliance.

Related product manuals