Page 26
Gas Jet Cleaning Procedure
x Every six months the gas jets on your
hob should be cleaned to ensure
continued efficient and safe operation.
x This may be done using a Gas Jet
Cleaning Kit which may be purchased
from your nearest Defy Service Centre.
x The kit comprises of a sliding T-bar (A)
a socket (B) and a ‘Classic pin’ (C).
x Fit the T-bar to the socket and
remove the pot stands, burner caps
and burner bodies.
1. Insert the socket into the central tube
of the burner so that it locates over the
brass gas jet at the bottom of the tube.
2. Gently loosen the brass gas jet by
turning the socket in an anti-clockwise
direction.
3. Carefully lift the socket and loosened
brass gas jet from the central burner
tube.
Replacing the oven lamp
DANGER Hot surfaces may cause
burns! Make sure that the appliance
is switched off and cooled down to
avoid the risk of an electrical shock.
The oven lamp is a special electric
light bulb that can stand up to 300 °C.
See Technical specifications for
details. Oven lamps can be obtained
from Authorised Service Agents.
Position of lamp might vary from the
figure.
If your oven is equipped with a round
lamp:
1. Disconnect the product from the mains.
2. Turn the glass cover counter clockwise to
remove it.
3. Refit the
glass cover.
4. Insert the Classic pin into central hole
of the jet and slide it up and down until
the jet is free of accumulated dirt.
5. Re-assemble in reverse order.
6. Clean all the burner jets in the manner
described above.
To Next Page
Loading...
