1. Shifts the first line displaying in the setup menus. Push two seconds to switch to master display in case
more than one display is connected.
2. Moves the cursor left for manoeuvring in the menus.
3. Increases the value of the selected set point (in the setup menu). In the daily use display, this button func-
tion is used for scrolling the second line displaying of generator values.
4. Selects the underscored entry in the fourth line of the display.
5. Moves the cursor right for manoeuvring in the menus.
6. Decreases the value of the selected set point (in the setup menu). In the daily use display, this button
function is used for scrolling the second line displaying of generator values.
7. Changes the menu line (line four) in the display to mode selection.
8. Jumps one step backwards in the menu (to previous display or to the entry window).
9. Shifts the display three lower lines to show the event and alarm list. The list holds 150 events. These
events are deleted when the AGC is switched off.
10. Manual activation of close breaker and open breaker sequence if "SEMI-AUTO" is selected.
11. Manual activation of close breaker and open breaker sequence if "SEMI-AUTO" is selected.
12. Stop of the genset if "SEMI-AUTO" or "MANUAL" is selected.
13. Start of the genset if "SEMI-AUTO" or "MANUAL" is selected.
14. Enters a specific menu number selection. All settings have a specific number attached to them. The
JUMP button enables the user to select and display any setting without having to navigate through the
menus (see later).
15. Shifts the display three lower lines to show the alarm list.
AGC-4 quick start guide 4189340689 UK
Display push-buttons and LEDs
DEIF A/S Page 20 of 26
To Next Page
Loading...
