6.4.1. Voltage range...............................................................................................................................18
6.5. Terminals.............................................................................................................................................. 18
6.5.1. Terminals..................................................................................................................................... 18
7. Protections
7.1. Protections check.................................................................................................................................19
7.1.1. Points to be considered............................................................................................................... 19
7.1.2. Considerations.............................................................................................................................19
7.1.3. Configuration of the protections...................................................................................................19
8. Adjustment
8.1. Adjustment overview............................................................................................................................ 21
8.1.1. Overview......................................................................................................................................21
8.2. Adjusting PID controller........................................................................................................................21
8.2.1. PID controller...............................................................................................................................21
8.2.2. Step 1, adjustment of the KP.......................................................................................................21
8.2.3. Step 2, adjustment of the Ti.........................................................................................................21
8.2.4. Step 3, adjustment of the Td........................................................................................................21
8.2.5. Step 4, readjustment of controller settings.................................................................................. 22
8.2.6. Manual governor and AVR control...............................................................................................22
8.2.7. Manual mode/switchboard control...............................................................................................22
8.2.8. Semi-auto mode (AGC 200/AGC-3/AGC-4 only).........................................................................22
8.2.9. Auto and test mode (AGC 200/AGC-3/AGC-4 only)....................................................................23
8.3. Relay output adjustments.....................................................................................................................23
8.3.1. Relay output adjustments............................................................................................................ 23
8.4. Resulting speed/voltage curve upon load change................................................................................23
8.4.1. Resulting speed/voltage curve upon load change.......................................................................23
9. Troubleshooting
9.1. Troubleshooting for Multi-line 2 and Uni-line products......................................................................... 25
9.1.1. Remedy of problem..................................................................................................................... 25
General guidelines for commissioning
4189340703 UK
DEIF A/S Page 3 of 25
To Next Page
Loading...
