PPM Installation Instructions
DEIF A/S Page 2 of 69
Table of contents
1.
ABOUT THIS DOCUMENT .................................................................................................... 3
INTENDED USERS.......................................................................................................................... 3
CONTENTS/OVERALL STRUCTURE .................................................................................................. 3
DEFINITIONS ................................................................................................................................ 3
2. WARNINGS AND LEGAL INFORMATION ........................................................................... 4
LEGAL INFORMATION AND RESPONSIBILITY ..................................................................................... 4
ELECTROSTATIC DISCHARGE AWARENESS ..................................................................................... 4
SAFETY ISSUES ............................................................................................................................ 4
3. GENERAL HARDWARE DESCRIPTION .............................................................................. 5
HARDWARE .................................................................................................................................. 5
4. DIESEL GENERATOR I/OS ................................................................................................... 6
DG UNIT WITH PMS PROCESSOR .................................................................................................. 6
DG UNIT WITHOUT PMS PROCESSOR .......................................................................................... 20
5. SHAFT GENERATOR I/OS .................................................................................................. 34
SG WITH FIXED FREQUENCY ....................................................................................................... 34
6. BUS TIE BREAKER I/OS ..................................................................................................... 45
BUS TIE BETWEEN DG AND SG ................................................................................................... 45
7. ADDITIONAL OPERATOR PANEL ..................................................................................... 54
INSTALLATION OF AOP-2 ............................................................................................................ 54
8. WIRINGS .............................................................................................................................. 57
AC CONNECTIONS (3-PHASE) ...................................................................................................... 57
INTERNAL CANBUS WIRING ......................................................................................................... 58
OPTION H2, MODBUS RTU ......................................................................................................... 58
LOAD SHARING LINES .................................................................................................................. 60
MECHANICAL SPEED GOVERNOR (STANDARD) .............................................................................. 61
AVR WITH RELAY OUTPUTS......................................................................................................... 61
ELECTRONIC SPEED GOVERNOR .................................................................................................. 62
AVR WITH ANALOGUE OUTPUTS (REQUIRES OPTION D) ................................................................ 62
BINARY INPUTS ........................................................................................................................... 63
BINARY INPUTS WITH WIRE BREAK SUPERVISION .......................................................................... 63
ANALOGUE INPUTS ..................................................................................................................... 64
OPTOCOUPLER OUTPUTS FOR EXTERNAL COUNTER ...................................................................... 64
9. GENERAL DATA ................................................................................................................. 65
TECHNICAL SPECIFICATIONS ....................................................................................................... 65
UNIT DIMENSIONS ....................................................................................................................... 68
PANEL CUTOUT (IN MM) ............................................................................................................... 69
To Next Page
Loading...
