PPM Installation Instructions
DEIF A/S Page 3 of 69
1. About this document
This document is the Installation Instructions for DEIF’s PPU Power Management system PPM.
The document mainly includes general hardware description, I/O lists for diesel, shaft and bus tie
generator, wiring descriptions and FAT information.
The general purpose of these installation instructions is to give the user important information to be
used in the installation of the PPM system.
Intended users
These installation instructions are mainly intended for the panel builder designer in charge. On
the basis of this document, the panel builder designer will give the electrician the information he
needs in order to install the PPM system, e.g. detailed electrical drawings. In some cases the
electrician may use these installation instructions himself.
Contents/overall structure
This document is divided into chapters, and in order to make the structure simple and easy to
use, each chapter will begin from the top of a new page.
Definitions
Throughout this document a number of notes and warnings will be presented. To ensure that these
are noticed, they will be highlighted in order to separate them from the general text.
Notes
Warnings
Please make sure that you read this manual before starting to work with the
PPM system. Failure to do this could result in damaging the equipment or
even worse injury of personnel.
The notes provide general information which will be helpful for the reader to
bear in mind.
The warnings indicate a potentially dangerous situation which could result in
death, personal injury or damaged equipment, if certain guidelines are not
followed.
To Next Page
Loading...
