Delem
V0614, 2.4
Figure 1.b
The installation program will now check for valid software that can be installed on the control.
In case various update sets are present, it is possible to select one of them through the
listbox. The standard updater offers several update sets:
• DA-52 Application
• DA-52 Factory Default
• etc...
A set called ‘DA-52s Application’ is used to upgrade the control Operating system and the DA
application, without affecting the existing user data (products, tools, materials) on the control.
A set called ‘DA-52s Factory Default’ is typically used for first time installation of all software
on a DA-52s control, including example products, tools and materials. If this update set is
used on a control which already contains such user data, this data may be overwritten.
If the correct update set is shown, press “Continue>>” to continue.
To Next Page
Loading...
