Delem DAC-310 - Table of Contents

Delem
V1204, 1.2
Table of contents
PART I - HARDWARE DESCRIPTION .............................................................................. 3
1. INTRODUCTION ............................................................................................................ 4
2. SPECIFICATIONS .......................................................................................................... 5
2.1. Physical dimensions ................................................................................................... 5
2.2. Environmental conditions........................................................................................... 5
2.3. Technical specifications ............................................................................................. 6
3. SCHEMATICS ................................................................................................................. 7
3.1. Connection diagrams.................................................................................................. 7
3.2. Physical dimensions ................................................................................................. 10
3.3. Time cycle ................................................................................................................ 11
PART II - MACHINE PARAMETERS................................................................................. 1
1. I/O ASSIGNMENTS ........................................................................................................ 2
2. THE MACHINE PARAMETERS.................................................................................. 6
2.1. The menu.................................................................................................................... 6
2.2. Short parameter list .................................................................................................... 6
2.3. Drive types ................................................................................................................. 8
2.3.1. Servo drive ......................................................................................................... 8
2.3.2. AC drive ............................................................................................................. 9
2.3.3. Unipolar system................................................................................................ 11
2.4. Parameter explanation .............................................................................................. 13
3. SOFTWARE SETTINGS .............................................................................................. 32
3.1. Parameter back-up.................................................................................................... 32
3.2. Upgrade control........................................................................................................ 34
3.3. Reset counters........................................................................................................... 34
PART III - THE DIAGNOSTIC PROGRAM....................................................................... 1
1. GENERAL REMARKS................................................................................................... 2
1.1. Outputs ....................................................................................................................... 2
1.2. Components check ..................................................................................................... 2
2. TEST-MENU .................................................................................................................... 3
2.1. Start ............................................................................................................................ 3
2.2. Test functions .............................................................................................................4
APPENDIX A - REFERENCE LIST ..................................................................................... 1