Dell EMC PowerEdge MX7000 - Configure ESXi via Web Interface

Figure 41. IPv4 conguration page
8 Enter the IPv4 Address,Subnet Mask, and the Default Gateway, and then press Enter to conrm.
9 Select DNS Conguration, and then press Enter.
10 Enter the IP addresses of the DNS servers and FQDN of the host.
11 Press Esc to return to the main menu, and then press Y to conrm the changes and restart the management network.
12 From the main menu, click Test Management Network.
The target IP addresses and DNS hostname are pre-populated.
13 Press Enter to perform the network test, and after the test is completed, press Enter to return to the main menu.
CAUTION
: If the network test fails, troubleshoot and resolve the issues before proceeding further.
14 From the main menu, select Troubleshooting Options > Enable ESXi Shell, and then select Enable SSH (required during validation
and deployment phases) to enable the ESXi shell.
15 Press Esc to return to the main menu.
Congure ESXi settings using web interface
Prerequisite
Before conguring ESXi settings using web interface, you must congure the ESXi settings using DCUI. For more information, see
Congure ESXi settings—using DCUI.
Steps
1 Using a web browser, go to the ESXi host-level management web interface at https://<ESXi Host Address>/ui.
2 Enter the credentials that were created during the ESXi installation, and then click Log in.
3 In the Navigator pane, click Networking.
The current port groups on the host are displayed by default. One is congured with VLAN information that is entered during
installation and the other is still at zero.
4 Right-click VM Network and then click Edit settings.
70
Deploy ESXi to cluster nodes