NOTE: The expansion card riser 1 and the x16 link on the riser 2 slot can be used only when both the processors are
installed.
1. Holding the touch points, lift the expansion card riser from the riser connector on the 系统 board.
Figure 48. Removing the expansion card riser 1
a. expansion card riser 1
b. connector
c. riser guide pin
Figure 49. Removing the expansion card riser 3
a. expansion card release latch
b. expansion card riser 3
c. connector
2. If applicable, remove or install an expansion card on the riser.
3. Install the expansion card riser.
Follow the procedure listed in the After working inside your system section.
108
安装和卸下系统组件
To Next Page
Loading...
