EasyManua.ls Logo

Dell EMC PowerEdge R630 - Removing an Internal SD Card; Installing an Internal SD Card

Dell EMC PowerEdge R630
189 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Identifier GUID-F755A31E-CC40-44AB-8DFC-39A0672FEBC8
Version 3
Status Released
Removing an internal SD Card
CAUTION:
Dell
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your section.
Locate the SD card slot on the internal dual SD module or the backplane expander board and press inward on the card to release
it from the slot and remove the card.
Follow the procedure listed in the After working inside your section.
Related references
on page 72
Related tasks
on page 73
on page 73
Installing an internal SD card on page 114
Identifier
GUID-FC074AF7-190B-405A-9CD8-2F5A2BFEDDCE
Version 3
Status Released
Installing an internal SD card
CAUTION:
Dell
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your section.
NOTE: To use an SD card with your , ensure that the internal SD card port is enabled in the System Setup.
1. Locate the SD card connector on the internal dual SD module or the backplane expander board. With the label side facing up,
insert the contact-pin end of the card into the slot.
NOTE: The slot is keyed to ensure correct insertion of the card.
2. To lock the card into place, press it into the card slot.
Follow the procedure listed in the After working inside your section.
Related references
on page 72
Related tasks
on page 73
on page 73
Removing an internal SD Card on page 114
114

Table of Contents

Related product manuals