Figure 86. Installing the 2.5-inch (x10) hard drive backplane
1. release tab 2. SD signal cable
3. SD signal cable connector 4. SAS cables (2)
5. SAS cable connector (2) 6. guide pin
7. guide pin slot 8. backplane
Figure 87. Installing the 1.8-inch (x24) hard drive backplane
1.
SD signal cable (3) 2. SD signal cable connector (2)
3. SAS cables (4) 4. SAS cable connector (4)
5. guide pin 6. guide pin slot
7. backplane 8. release tab (2)
1. Install the hard drives in their original locations.
2. Follow the procedure listed in the After working inside your system section.
Related references
安全说明 on page 72
获取帮助 on page 188
使用系统诊断程序 on page 167
150
安装和卸下系统组件
To Next Page
Loading...
