Creation of the bootable USB drive begins.
8. After the creation of the bootable USB drive is complete, open the folder to ensure that the required files are listed, as shown in the
following figure:
Figure 10. Grub file location
9. Using the Notepad or similar application, double-click to open the grub.cfg file.
10. From the linux image line, add console=ttyS0,115200 as shown in the following figure:
Figure 11. Edit grub.cfg file
11. Save the changes that are made to the grub file, then close the file.
12. Plug the bootable USB drive that you created in step 1, into the USB port of the VEP1405 series system.
NOTE:
Perform the same steps listed in this section to create a bootable USB drive for the Red Hat Enterprise Linux
(RHEL) and ADVA ISO images. See the Introduction section for the Red Hat Enterprise Linux (RHEL) and ADVA ISO
image file information.
Create bootable USB drive 11
To Next Page
Loading...
Need help?
General
